Description
Get the weight off your back and onto the bike! A loaded backpack wears you out by lunch and throws you off balance in the tight stuff. The Backcountry Tunnel Bag gets more stuff off your back and onto the tunnel, where it rides low and stays put. Your avy pack carries the essentials, and you carry a whole lot less weight
Super lightweight, extremely durable, and completely waterproof. Everything you want in a tunnel bag and nothing you don't.
-
Completely waterproof - sealed seams and waterproof zippers, so snow, slush and spray stay outside
- Big zip pullers you can work with gloves on
- Super light, seriously tough - under 2 lb, even the Long. Adds storage, not a bunch of weight, and holds its shape whether it's full or half empty, so it won't sag or flop around
- Lid opens all the way - the whole lid flips open, so everything's right there. No more digging
- Adjustable Velcro divider - tools on one side, lunch on the other. Nobody wants a sandwich that tastes like chain lube :)
- Sealed pocket on top - for your spare gloves. Swap to a dry pair without unpacking the whole bag
-
Two sizes
- Long - for 129" and longer tunnels on YETI SnowMX, Timbersled and MTN.TOP. 18" L x 8.5" W x 7" H (46 x 22 x 18 cm), 1.9 lb
- Short - for the shorter tunnels, and it fits the long ones too. 13" L x 8.5" W x 7" H (33 x 22 x 18 cm), 1.6 lb
-
Everything to mount it is in the box - hardware kit plus a drill template. Mark it, drill four 1/4" holes, bolt it on. Full steps are on the Installation tab
- Running a YETI carbon rack? It comes with the holes already drilled, so the bag bolts straight on
- Grab handle - something to hang onto while you zip it shut
Not sure which size? If in doubt, go short. It fits both.
Need even more storage room on the bike? Pair it with the Stealth Under-Fender Storage Bag. Load it up, zip it shut, go ride.
Want to see it up close? Check out the Videos tab.
CAST1909 - Long
CAST1907 - Short
Installation
Every bag comes with everything you need to mount it: a hardware kit and a drill template.
What's in the box
- Backcountry Tunnel Bag (Long or Short)
- Hardware kit: 4 bolts, washers, rubber washers and lock nuts
- Drill template with instructions
How to mount it
- Centre the drill template on your tunnel (or wherever you're mounting the bag).
- Mark the 4 hole centres with a centre punch or a fine-tip marker.
- Drill the holes to 1/4". Wear safety glasses.
- Bolt the bag on with the supplied hardware, stacked as shown below.
Tip: Put masking tape over the hole spots to protect the surrounding area from scratches.
Drilling a carbon fibre tunnel?
- Wear a dust mask
- Use a brad-point bit if you have one
- Back the hole with a wood block to prevent blowouts
- With a standard twist bit, use high RPM and light pressure. You want to wear your way through, not snag the fibres
- When you're almost through, ease off to gently break through the back side
Running a YETI carbon rack?
It comes with the holes already drilled, so skip the drilling and bolt the bag straight on.
Videos
Check out the C3 Backcountry Tunnel Bags up close!